WWZMDiB L298N Motor Driver Controller Board Module for Arduino Smart Car Power UNO MEGA R3 Mega2560 ?L298N Motor Driver Controller Board Module?:L298N as main chip.Can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors. ?Operating mode?: H-bridge driver (dual) Logic voltage?:5V(current 0mA-36mA) Drive voltage?: 5V-35V(current: 2A (MAX single bridge) Maximum power?: 25W ?Size?:43x43x27mm To avoid damage the voltage stabilizing chip, please use an external 5V logic supply when using more than 12V driving voltage This module has a built-in 5v power supply, when the driving voltage is 7v-35v, this supply is suitable for power supply DO NOT input voltage to +5v supply interface, however ledding out 5v for external use is available. When ENA enable IN1 IN2 control OUT1 OUT2 When ENB enable IN3 IN4 control OUT3 OUT4

To avoid damage the voltage stabilizing chip, please use an external 5V logic supply when using more than 12V driving voltage. ?Size?:43x43x27mm. Maximum power?: 25W. Drive voltage?: 5V-35V(current: 2A (MAX single bridge). Logic voltage?:5V(current 0mA-36mA). ?Operating mode?: H-bridge driver (dual). ?L298N Motor Driver Controller Board Module?:L298N as main chip.Can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors.