How to Get the Accurate Measurement Result

1. Before blood collection, wash your hands with warm water or neutral soap and rub the fingers of blood collection repeatedly until the blood volume is rich. You could disinfect finger abdomen with 75% alcohol, collect blood after alcohol evaporated.
2. Before each test, make sure that the surface of strip is free from moisture or other contamination, and avoid touching the blood sampling area of the strip.
3. Close the cap on the bottle immediately after taking out the strip. It is best to use the strip within 3 minutes of taking it out.
4. Blood droplets should be collected and tested immediately after formation. Collecte blood volume to ensure a full, don't add blood for a second time.
5. If it didn't bleed after pricking your finger, or the blood is insufficient, it is best to hang your hand naturally and wait for 5 seconds. If necessary, squeeze from the center of the palm to the fingertips. Do not directly squeeze the fingertips. Or adjust the depth of the lancing device to collect blood again.
6. Take turns collecting blood from different fingers. Blood collection on the ventral side of the finger is not only less painful, but also adequate.
7. No Control Solution is required, please do not purchase additional control solution.
8. Remove a new test strip within the valid expiration date from vial. After taking the strip, immediately cover the vial. To avoid losing efficiency. Insert test strip into the strip slot, the test strip is suggested to use up within 3 minutes.
9. Write the discard date (6 months after first opening the vial) on the vial label when you first open it. Discard the remaining test strips after the discard date.
10. Test Strips are for single use only. Never reuse a test strip that has had blood applied to it.