Installation instructions
1. This product is only applicable to automobile nstallation with 12V power supply. If it is installed directly on the 24V vehicle or the 24V vehide without lowering voltage, the machine will be burnt out.
2. Before install to the car, wrap the unnecessary wire, don't expose the copper wire outside, avoid touching the power supplyor ground wire, burn out the machine and make it unable to open, no sound.
3. The connection must be made according to the wiring diagram. Failure to connect properly may cause machine failure or damage to the vehice's electrical system.
4. The hom(+. -)lead must be connected to the speaker (+. ) teminal. Do not connect the car body or interconnect the speakers.
5. Please do not plug the vent or heat dissipation plate to avoid the instability of machine performance caused by intermal overheating.
6. In order to drive safely, it is recommended to set "turn ON the brake control' as "ON" in the output control of the system, then the image will be displayed only when the brake is applied, while the sound will only be output without the image, and the screen will prompt "handbrake".