STEP 1

Gently hold the end protector open with your fingers, put the whole white part of lightning data head into the slot, and then adjust the position of your data header to the proper position to avoid sliding down.

Remark:

• You can add after twist the whole cable including the weak joints if you want a stronger protection

STEP 2

Simply twist the whole cable from top to bottom. Make sure doing it close and tight to prevent any gaps between your spirals.

STEP 3

Put the charger case on

Remark:

• Be aware Non-standard 18/20w charger may not suit which may probably stuck during pulling out.

STEP 4

Add the wire tie & cut the leftovers of the wrap wire