2nd Generation Home Alarm System
1, Make Sure before Pairing:
Connect your smartphone to your home wifi. Make sure your wifi signal is 2.4GHz.
2, Pairing the Base Station with Your Smart Phone
- Slide the button to the left to turn on the base station.
- At this time, turn on your smartphone’s Bluetooth. Create an account and add base station by tap”+” on the upper right, tap”Auto scan” then tap “Start scanning”.
- Tap “Go to add” Select 2.4 GHz Wi-Fi network and enter password. Then tap Confirm. Tap “Done “after the device is successfully added. You can control your accessories by smart phone from now on.
.
3, Pairing the Accessories with your Smart Phone.
- Tap "Accessories" at the bottom of the app to set up the sensors/remotes.
- If you want to add motion sensors/contact sensors, tap "Sensors", tap "+ Add". If you want to add remotes/Keypads, tap "Remotes", tap"+Add".
- Trigger your sensors at this time.
- Contact Sensor: Line up the contact sensor together then seperate the 2 parts of the contact sensors.
- Motion Sensor: Wave your hands in front of the Motion Sensor.
- Remote Control: Pressing any button of the remotes.
- Keypads: Press and Hold the panic button on the keypad for 3 seconds.
.
Q: Will it make a noise when a door is opened and system is disarmed?
A: When the system is in disarm mode, there will be no beeping sound when you open the door. But if you encounter an abnormal situation, please set the door sensor only active in Away, Home Mode via app.
Q: When I'm alerted that the alarm was triggered, the alert dones not identify which sensor was triggered. The notification shows SOS.
A: The default name of each sensor is "Sensor". The default name of each remote/keypad is "Remote". After each sensor or remote is successfully paired, please modify the default name first. In this way, the notification will shows that which sensor or remote is triggered.
Q: If I receive false alarm, what should I do to solve the problem fundamentally?
A: There may be two reasons for false alarms. Reason 1: The two parts of the door sensor are installed too far. Reason 2: It is necessary to set each door sensor to alarm only in the "away mode". You could check the alarm history to confirm which door sensor was alarmed false. And reinstall it more closer. Please make sure the distance between 2 parts of door sensors is less than 15mm.