0

SpeedyBee F405 V3 Flight Controller: 30x30 Drone FC Wireless Betaflight Configuration Blackbox Solder-Free Plugs WiFi Bluetooth for 3-6S 4" 5" FPV Racing Drone Cinelifter

 
Be Safe - We Directly Ship From Country of Origin
 
BE SAFE
WE ONLY SOURCE
FROM OFFICIAL SUPPLIERS
 
From United States
To International
In 5-10 Days
US$19.99 Shipping Fees for any Order
 

GRAND SELECTION

Think of it and most probably we have it among our grand selection of products!

 

AMAZING PRICES

Get ready for the amazing and best Supps prices ever!

 

FIXED RATE DELIVERY

Get your order anywhere on this planet within 5-10 days with a fixed rate of $19.99 (no matter the size of your order)

 

 

 
 

SpeedyBee F405 V3 Flight Controller: 30x30 Drone FC Wireless Betaflight Configuration Blackbox Solder-Free Plugs WiFi Bluetooth for 3-6S 4" 5" FPV Racing Drone Cinelifter





Regular Price: US$101.99

Special Price US$84.99

Availability: In stock


Supplier: SPEEDY BEE

Category: Electronics Computers & Accessories Computer Components Single Board Computers




SpeedyBee F405 V3 30x30 Flight Controller Specifications

  • MCU: STM32F405
  • IMU(Gyro): BMI270
  • USB Port Type: Type-C
  • Barometer: Built-in
  • OSD Chip:AT7456E chip
  • BLE Bluetooth: Supported. Used for Flight Controller configuration (MSP should be enabled with Baud rate 115200 on UART4)
  • WIFI: Not supported
  • DJI Air Unit Connection Way:Two ways supported: 6-pin connector or direct soldering.
  • 6-pin DJI Air Unit Plug: Supported. Completely compatible with DJI O3/RunCam Link/Caddx Vista/DJI Air Unit V1, no wire is needed to be changed.
  • Blackbox MicroSD Card Slot:you could use any SD card less than 32GB, but the Betaflight can only recognize 4GB maximum. We suggest you use this 3rd party formatting tool and choose 'Overwrite format' then format your card.
  • BetaFlight Camera Control Pad: Yes(CC pad on the front side)
  • Current Sensor Input: Supported. For SpeedyBee BLS 50A ESC, please set scale = 386 and Offset = 0.
  • Power Input: 3S - 6S Lipo(Through G, BAT pins/pads from the 8-pin connector or 8-pads on the bottom side)
  • 5V Output:9 groups of 5V output, four +5V pads and 1 BZ+ pad( used for Buzzer) on front side, and 4x LED 5V pads. The total current load is 2A.
  • 9V Output:2 groups of 9V output, one +9V pad on front side and other included in a connector on bottom side. The total current load is 2A.
  • 3.3V Output: Supported. Designed for 3.3V-input receivers. Up to 500mA current load.
  • 4.5V Output: Supported. Designed for receiver and GPS module even when the FC is powered through the USB port. Up to 1A current load.
  • ESC Signal:M1 - M4 on bottom side and M5-M8 on front side.
  • UART:6 sets(UART1, UART2, UART3, UART4(Dedicated for Bluetooth connection), UART5(Dedicated for ESC telemetry),UART6
  • ESC Telemetry: UART R5(UART5)
  • I2C: Supported. SDA & SCL pads on front side. Used for magnetometer, sonar, etc.
  • Traditional Betaflight LED Pad: Supported. 5V, G and LED pads on bottom of the front side. Used for WS2812 LED controlled by Betaflight firmware.
  • Buzzer:BZ+ and BZ- pad used for 5V Buzzer, BOOT Button:Supported.
  • RSSI Input: Supported. Named as RS on the front side.
  • Smart Port / F.Port: Not supported
  • Supported Flight Controller Firmware: BetaFlight(Default),INAV (INAV firmware can only use Multishot (recommended) and OneShot125. Please note that DShot is not supported.), Firmware Target Name SPEEDYBEEF405V3
  • Mounting: 30.5 x 30.5mm( 4mm hole diameter)
  • Dimension: 41.6(L) x 39.4(W) x 7.8(H)mm
  • Weight: 9.6g

V3 V3 f4 fc Mini F7 FC ESC Stack
V3 F7 FC V3 F4 FC Mini F7 FC
Mounting 30.5 x 30.5mm( 4mm hole diameter) 30.5 x 30.5mm( 4mm hole diameter) 20x20mm(3.5mm hole diameter)
MCU Chip STM32F722 STM32F405 STM32F722
Bluetooth Chip Supported. Used for FC configuration Supported. Used for FC configuration Supported. Used for FC configuration
Wireless FC Firmware Flashing ✓ No Supported No Supported
Wireless Blackbox Download&Analysis ✓ No Supported No Supported


If you receive a defective or incomplete item, please contact us immediately for assistance before you apply for a return. [SpeedyBee Advantage]: Download SpeedyBee App on your mobile devices, free to change the settings of flight controller and ESC anywhere without a computer. [More Features& Warranty]:Support up to 8 motors,Built-in 4 x LED plugs,Onboard 4-level battery life indicators. Feel free to contact us for help by scanning the QR code,or get help on Speedybee APP. [Get Blackbox Data in 1 Minute]: With an optimized Bluetooth/WiFi chip, you just need to take your smartphone out, connect, and download your flight in 20 seconds.Come with 500MB super huge onboard Blackbox flash memory. [Solder-free Installation]: Come with two installation methods,one side has plugs port for your digital video transmitter, receiver, camera, VTX, and GPS,4x LED plugs. Another side for soldering by yourself. [Wireless FC ESC Tuning]: 33% faster wireless data transfer than the last version. Update FC firmware wirelessly in just 1 minute! Connect via Bluetooth and fully configure any setting for Betaflight/Emuflight/INAV.
 
Be Safe - We Directly Ship From Country of Origin
 
BE SAFE
WE ONLY SOURCE
FROM OFFICIAL SUPPLIERS
 
From United States
To International
In 5-10 Days
US$19.99 Shipping Fees for any Order
 

GRAND SELECTION

Think of it and most probably we have it among our grand selection of products!

 

AMAZING PRICES

Get ready for the amazing and best Supps prices ever!

 

FIXED RATE DELIVERY

Get your order anywhere on this planet within 5-10 days with a fixed rate of $19.99 (no matter the size of your order)

 

 

 
 
Verified Customers Reviews
My Cart
Item
Continue Shopping