The SparkFun Artemis Development Kit is the latest board to be released around the SparkFun Artemis Module and it allows access to more software development features than previous Artemis based boards. Recommended software used to program the Artemis DK are the compatible with Arduino IDE, Arm Mbed OS (Studio and CLI), and AmbiqSDK. The Artemis Module provides a Cortex-M4F with BLE 5.0 running at 48MHz with an available 96MHz turbo mode and power as low as 6uA per MHz (less than 5mW). The SparkFun Artemis Module is fully FCC/IC/CE Certified 8/16/2019 (ID Number 2ASW8-ART3MIS) with 1M flash and 384k RAM you'll have plenty of room for your code. The flexibility of the Artemis module starts with our compatible with Arduino core. You can program and use the Artemis module just like you would an Uno or any other microcontroller. Additional functionality stems from the ability of the Artemis Dev kit to run RTOS such as the Arm Mbed OS, or the AmbiqSDK. Attached to the "Qwiic" I2C bus, we've added a LIS2DH12TR MEMS accelerometer (for things like gesture recogntion), a digital MEMS microphone, and an edge camera connector for the Himax CMOS imaging camera (not included) to experiment with always-on voice commands, and image recognition with TensorFlow and machine learning. All of the Artemis Development Kit pins are broken out to 0.1" spaced female headers (i.e. connectors). There are also two rows of breakout pins with .1" pitch spacing for headers; and a .08" pitch spacing to clip on IC-hooks, used by most logic analyzers. Additionally the Silk on the back of the Artemis DK acts as a chart to show pins by functionality (peripherals, ADC, PWM, UART0, & UART1) and act as an aid while developing software. The board is powered & programmed via USB-C, and includes a Qwiic connector to make I2C easy and is fully compatible with SparkFun's compatible with Arduino core to be programmed under the compatible with Arduino IDE.

Sensors: 3-axis Accelerometer (LIS2DH12), PDM Microphone (SPH0641LM4H-1), Camera Connector (for the Himax HM01B0 Camera). Board Only. Artemis Module:Apollo3 ARM Cortex-M4F MCU, BLE 5.0 with FCC/IC/CE Certification 8/16/2019 (ID Number 2ASW8-ART3MIS), 24 Breakout I/O Pins, Eight 14-bit ADC Pins, Eighteen 16-bit PWM Pins, Two Independent UART Ports, Three Peripheral I2C/SPI Buses, JTAG Programming PTH. Power:5V Provided Through the USB-C Connector and 1.8V, 3.3V, and 5V Available on Power Header. Qwiic Connector On Primary I2C Bus. Mass Storage Device (MSD): Used to provide drag and drop programming to the Artemis Module. Human Interface Device (HID): Used for the debugging interface to the Artemis Module. Communication Port (COM): Used to provide a serial communication UART between the Artemis and the USB connection (PC). An updated USB interface (MKL26Z128VFM4 Arm Cortex-M0+ MCU, from NXP). Compatible with Arduino, Mbed OS, and AmbiqSDK Development Programs. Drag and Drop Programming, SWD Interface, and JTAG Programming PTH.