SparkFun 16x2 SerLCD - RGB Backlight (Qwiic) - Compatible with Arduino LCD Communicate Over Serial I2C and SPI 3.3V Compatible

BE SAFE

WE ONLY SOURCE

FROM OFFICIAL SUPPLIERS

From United States

To International

In 5-10 Days

US$19.99 Shipping Fees for any Order

GRAND SELECTION

Think of it and most probably we have it among our grand selection of products!

AMAZING PRICES

Get ready for the amazing and best Supps prices ever!

FIXED RATE DELIVERY

Get your order anywhere on this planet within 5-10 days with a fixed rate of $19.99 (no matter the size of your order)

+1 (844)-467 8777

PHONE:

+1 (844)-467 8777

SparkFun 16x2 SerLCD - RGB Backlight (Qwiic) - Compatible with Arduino LCD Communicate Over Serial I2C and SPI 3.3V Compatible

Regular Price: US$47.99

Special Price US$39.99

Availability: In stock

Supplier: SparkFun

Category: Electronics Computers & Accessories Computer Components Single Board Computers

Qty:

Frequently bought together :

Price for all selected :

US$59.98

Since 2003, SparkFun has been helping turn ideas into reality. We're here to help you start something.

The SparkFun SerLCD is an AVR-based, serial enabled LCD that provides a simple and cost effective solution for adding a 16x2 Black on RGB Liquid Crystal Display into your project. We've seriously overhauled the PCB design on the back of the screen by including an ATmega328P that handles all of the screen control, meaning a backpack is no longer needed! This display can now communicate in three different ways: serial, I2C, and SPI. This version comes equipped with a Qwiic connector, bringing serial LCDs into the Qwiic ecosystem. This simplifies the number of wires needed and allows your project to display all kinds of text and numbers. The on-board ATmega328P AVR microcontroller utilizes 11.0592 MHz crystal for greater communication accuracy with adjustable baud rates of 1200 through 1000000 but is default set at 9600. The firmware for this SerLCD is fully opensource and allows for any customizations you may need. Note: Since the SerLCD is a 3.3V device, please make sure you convert to 3.3V logic depending on your chosen microcontroller or single board computer. Otherwise, you may risk damaging your board. The SparkFun Qwiic Connect System is an ecosystem of I2C sensors, actuators, shields and cables that make prototyping faster and less prone to error. All Qwiic-enabled boards use a common 1mm pitch, 4-pin JST connector. This reduces the amount of required PCB space, and polarized connections mean you can’t hook it up wrong. See more

Open-sourced firmware and compatible with Arduino bootloader enables updates via the IDE. Dimensions (LxWxH): 80.29x35.90x14.09mm. Weight: 0.0766 oz. Pulse width modulation of backlight allows direct control of backlight brightness and current consumption. Pulse width modulation of contrast allows for software-defined contrast amount. Emergency reset to factory settings (Jumper RX to GND on bootup). Operational backspace character. Incoming buffer stores up to 80 characters. User-definable splash screen. Three communication options: Serial, I2C and SPI. 16x2, Black on RGB Display. Qwiic connection. Adjustable I2C address controlled via software special commands (0x72 default). The AVR ATMega328p (with compatible with Arduino bootloader) is populated on the back of each LCD screen and handles all of the LCD control.