Steps of using paste

1.Peel off the backing adhesive strip of the screen stencil, straighten it and press it over the surface without curling.

2.Transfer the desired chalk paste with squeegee onto the stencil you want. Apply the chalk paste lightly and complete the process quickly to avoid paste being dry out.

3. Peel off the silk screen stencil slowly. Be careful no chalk paste fall onto your clothes and other things. If apply on fabric, heat this to make the transferred pattern better.

4. Clean the stencils with water quickly before the paint is dry. Take it out and dry it. After the adhesive side is completely dry, place stencils on the backing adhesive strip.

Steps of mixing the paste

1. Please choose to use a soft rubber squeegee or screen printing pen to transfer your desired paint onto a silk screen stencil or a smooth surface for mixing.

2. When you're done, transfer the mixed creative paste to where you want it to be applied.

Steps to restore the paste - when the paste dries

1. Add a small amount of water at a time into the chalk paste bottle.

2. Mix and stir with a squeegee or screen printing pen.

3. Repeat this until the paste is back to its original, becomes a thick consistency as before.

If adding too much water causes the paste to become runny, please open the lid of the paste bottle to allow the water evaporate until the paste becomes thick again.

Steps to handle the dissatisfied points

1. For the points that you are not satisfied with, you can simply wipe off the excess paste with a wet wipe. Or choose to scrape paste off with a squeegee before it gets dry.

2. When being sanded is required if the paste needs to be removed from a non-porous surface, such as a mirror after being dry.