Patch Panel 24 Port Cat6A with Inline Coupler Built for Easy Use, Excellent Speed and Reliable Connectivity

The Rapink ethernet patch panel support excellent performance transmission up to10-Gigabit, compatiable with the TIA/EIA 568-C.2 standard and cat7, cat6a, cat6, cat5e, cat5e UTP and STP cabling system.

Standard 19-inch 1u patch panel suitable for Rackmount, Wallmount, or cabinets.

This patch cat 6 wall mount contains thick steel detachable back bar. With zip ties, the back bar helps with cable management and takes some stress off the coupler, improve the working stability of the network connection port, and avoid keystone loose and the occurrence of network failures.

Cat6a patch panel came with 10g couplers making it easier to connect the cables.

Use this to replace a punch down patch panel.

Plug and play on both sides for ethernet cables.

This 19 rack blank panel is less prone to failure as well.

CAT6A passthrough coupler tested full 10 gigabyte certified.

Clean up the look of your cabinet or wallmount in 10 minutes.

Inline modular patch panel much better than punching down Keystones

These cat6 shielded patch panel were easy to install and use. Pass through design is more friendly to non-professional person since it is use terminated cables and plugged directly into switches.

Coupler patch panel let you don’t have to spend time wiring Cat5/6 in order to get your system up and running.

This network patch panel cat 6 will make your rack look much cleaner.

Assembly Instruction for Cat6a Coupler Patch Panel

Just several stpes needed as following:

1. Plug all network cables into the back of keystone loaded on shielded patch panel cat6a.

2. Assembly detachable back bar into the patch panel

3. Fasten the network cable onto the back bar to sturdy cable and back bar. This stpe is very important to secure keystone, cable and back bar.

4. Put the whole patch panel onto standard 19 inch wall mount and screw the screw included.