Widely compatible for Ubiquiti & brands that don't require special coding such as: For Netgear AXM765; D-Link DEM-440XT; Supermicro, Linksys, ect.
Supports Links up to 30m using Cat 6a/7 Cable; SFF-8431 and SFF-8432 MSA Compliant
IEEE 802.3az Compliant; Low Power Consumption (2.5W MAX @ 30m); Fast Retrain EMI Cancellation Algorithm
Low EMI Emissions; I2C 2-Wire Interface for Serial ID and PHY Register Access; Auto-negotiates with other 10GBase-T PHYs; MDI/MDIX Crossover; Multiple Loopback Modes for Testing and Troubleshooting
Built-in Cable Monitoring and Link Cable Length Measurements Opens/Shorts
Robust Die Cast Housing; Bail Latch Style ejector mechanism; Unshielded and Shielded cable support
Supports 1000Mbps rate for using Cat 5e cable or better.
Thanks for Cristina, from Tarrytown , NY leave us very useful about ”How to make the module run on UDM PRO SE switch“, blow is Main part of content:
QSFPTEK 10G SFP+ RJ45 Module into Ubiquiti Dream Machine Special Edition and encountered a bit of a learning curve initially. The primary issue stemmed from the compatibility quirks with the Ubiquiti system rather than the module itself. Initially, when I installed the module with the system powered on and then rebooted, the Dream Machine's switch failed to recognize the port. However, I found a workaround by installing the module with the machine powered off, which then allowed it to be recognized in the UniFi user interface. Once this setup detail was addressed, the module performed flawlessly.