Instantly upgrade your network switch to PoE. Power an IP camera, desktop phone, WiFi access point, or other low voltage 802.3af device through a network data cable using this Passive Power over Ethernet (PoE) injector. A Passive PoE injector delivers the same voltage as its power source in passive mode that is “Always On”. This injector provides 48 volts, 15 watts of PoE power for devices labeled ‘802.3af’. Plug the midspan injector into the wall, put Data In one port, and receive Data + Power Out from the other port. This adapter extends 48-volt PoE up to 328 feet away from the source.

Convert non-PoE to PoE without needing to replace your existing switch or infrastructure. Benefit from versatility and customizability in your network configuration by adding PoE to any non-PoE switch, one port at a time. Great for home offices, temporary WFH setups, and small businesses utilizing PoE Splitters, security cameras, VoIP desktop phone systems, and WiFi Access Points.

10/100/1000 Gigabit Data Transfer

Our single port PoE adapter transmits 10/100/1000 Gigabit data, delivering lightning fast wired speeds with no loss of signal quality via one Data In port and one Data + Power Out port.

PoE for Compatible 15W Devices

• PoE Converters
• WiFi Access Points
• VoIP Phones
• IP Cameras
• 802.3af devices

NOTE: Compatible with IEEE 802.3af devices with “Always On” passive PoE

NOTE: Passive PoE is always on, so do not use on ports where a non-PoE device can be connected