Instantly upgrade your network switch to PoE+. Power an IP camera, desktop phone, WiFi access point, or other low voltage device through a network data cable using this Passive Power over Ethernet (PoE) injector. A Passive PoE injector always delivers the same voltage as its power source. This injector comes with a 48 volt, 30 watt DC power supply to power devices labeled ‘802.3af’ or ‘802.3at’. Send Data In one port, and receive Data + Power Out from the other port. Extend PoE to devices up to 328 feet away from the source.

Convert non-PoE to PoE or PoE+ without needing to replace your existing switch or infrastructure. Benefit from versatility and customizability in your network configuration by adding PoE to any non-PoE switch, one port at a time. Great for home offices, temporary WFH setups, and small businesses utilizing security cameras, VoIP desktop phone systems, and WiFi Access Points.

10/100/1000 Gigabit Data Transfer

This single port PoE adapter transmits 10/100/1000 Gigabit data, delivering lightning fast wired speeds with no loss of signal quality via one Data In port and one Data + Power Out port.

PoE+ for High-Powered Devices (Up to 30W)

• WiFi Access Points
• VoIP Phones
• IP Cameras
• PTZ Cameras
• 802.3af devices
• 802.3at devices

NOTE: Compatible with IEEE 802.3af/at devices with “Always On” passive PoE

NOTE: Passive PoE is always on, so do not use on ports where a non-PoE device can be connected