New NAIL SCULPTING ACRYLIC LIQUID MONOMER SALON HIGH QUALITY 100ml -10Litre UK Application Procedure Pour a small amount of monomer into a dappen dish -- use only what you will need for the particular service you are performing. Totally immerse and 'swish' your brush in the monomer to thoroughly wet the hairs and to remove any trapped air that may result in bubbles in the finished product. Air bubbles compromise the strength of the product and can lead to service breakdown. As you remove the brush from the dish, flatten hairs on both sides to shape the brush for sculpting and to drain excess liquid from the brush. Now you are ready for sculpting. More monomer = a larger bead, less monomer = a smaller bead. Dip the brush into the monomer according to the desired bead size. For a small bead, slide the flattened brush down the side of the dish and submerge only the tips of the flags (the darkest hairs) into the monomer. For a larger bead, moisten the entire flag area of the brush. Draw a line in the powder to the depth of the liquid line on your brush. The longer the line, the bigger the bead. Allow the monomer to surround the polymer particles. The bead should be medium in size and a medium-wet consistency. A medium-wet mix ratio will not immediately 'melt' down, it will have a slight 'textured glass' appearance, and maintain its shape when placed on the nail, tip or form. Place the bead at the smile line and in the center of the natural nail. Press the bead with the flags of the brush to flatten and separate the bead, then stroke to the extension edge. Press either side of center to flatten the bead and stroke to the extension edge, being sure that the level of product is evenly distributed. This section will be higher at the smile line (upper arch) and tapered to all edges. As you smooth with the brush from smile to extension edge, it is important to 'follow-through- with the stroke in a downward motion. With the entire section 1 covered fr

UV Filter.