Assembly Instructions:

Step 1. Remove storage cap or nipple and ring prior to assembling the bottle

Step 2. Simply push the bottle body into the base (do not attempt to twist shut).

Holding the base and bottle body across from each other, simply push together. Or, place base on a flat surface and push bottle body down into it. 

Preventing leaks - Make sure all edges are evenly aligned and flash tight.

Freezing Breastmilk:

1. Pump directly into bottle
2. Seal with storage cap and place deep in refrigerator
3. Use the nanobebe adaptor to pour into storage bag and freeze
4. Seal with storage cap and place deep in refrigerator
5. After defrosting, pour milk into bottle

Warm your nanobebe bottle in a bowl filled warm water. Fluid level should not reach the nipple ring. Tilt the bottle gently to remove any trapped air underneath, then swirl the bottle inside the water until the desired temperature is reached.

Always check the temperature of the milk before feeding your baby by dropping few drops on the inside of your wrist.

Important Reminder:

Storage cap must be removed from bottle prior warming.

Replace with nipple and travel cover.

Feeding:

Mimic Breastfeeding - Thanks to its natural, breast-like design, the nanobebe feeding bottle makes it easier to combine breast and bottle feeding. When baby is crying and hungry, you can speed up prep time without exposing the breast milk to nutrients damaging temperatures.

Hold this way to feed - Hold the bottle between your fingers and thumb. Make sure milk fills the nipple. With adult supervision, baby may hold the bottle while feeding.

Disassemble:

Step 1: Remove storage cap or nipple and ring prior to disassembling the bottle.

Step 2: To disassemble your nanobebe bottle simply push down on the lip to release the base from bottle body.

Cleaning and Sterilizing:

• Before first use, disassemble all parts and sterilize in a bowl with boiling water for 5 minutes. Wash in warm soapy water and rinse thoroughly. Dishwasher safe.
• It is recommended that the white silicone ring, located on your bottle body, be removed and cleaned after each use.
• After each use, sterilize using a nanobebe Microwave Steam Sterilizer or in boiling water for 5 minutes.

For Your Child's Safety:

• Never use this product without adult supervision.
• Never use feeding nipple as a pacifier.
• Continuous and prolonged sucking of fluids will cause tooth decay.
• Do not heat on the stovetop. Do not place in a heated oven.
• Always check food temperature before feeding.
• When using formula, follow the formula milk manufacturer's instructions and allow the freshly boiled water to cool before pouring into the bottle.
• To ensure the bottle functions correctly and to prevent leakage, always ensure nipple screw ring is tightly and evenly closed and bottle body is flush with bottle base.
• Expressed breastmilk can be stored in sterilized nanobebe bottles in the refrigerator up to 48 hours (not in the doors) or the freezer for up to 3 months. Never refreeze breastmilk or add fresh breastmilk to already frozen milk.
• Always wash your hands thoroughly and ensure surfaces are clean before contact with sterilized components. Do not place components directly on surfaces that have been cleaned with antibacterial cleaning agents.

Maintenance:

• Before each use, inspect all items. Pull the nipple in all directions. Throw away at first signs of damage or weakness.
• Do not leave a nipple in direct sunlight or heat, or leave in disinfected ("sterilizing solution") for longer than recommended, as this may weaken the nipple.
• Do not sore with or allow to come into contact with solvents or harsh chemicals.
• Keep all parts not in use out of reach of children.
• For safety and hygiene concentration of detergents may eventually cause plastic components to crack. To save storage space, stack two or more nanobebe feeding bottles sealed with storage caps.
• If not in use for over a week, the nanobebe feeding bottle should be stored disassembled.