*During installation, please connect the power cable of the backup camera to the harness wires that connect to the backup light on the tail light assembly.
*The RED wire end is positive, while the BLACK one is negative. And connect the RCA output end to the car monitor.
*The camera switch is controlled by the reverse gear shift.
*Please take care of the sealing to prevent water leakage when installation.
*ONLY the generic suitable tool can be helpful for you to release the set screw on the camera and adjust the camera up and down for desired view angle.
*When connecting this car backup camera to a FACTORY RADIO, a suited Harness & Programmer(not included because different RADIO need a different Harness & Programmer) will help you complete installation more efficiently.
*You can apply electrical tape for the joint of the red power wires and RCA wires, and use zip ties to fasten the wire on your vehicle.