Key Fob, keyless, entry, replacement, remote, transmitter, 2005, 2006, 2007, 2008, 2009, 2010, Honda Odyssey OUCG8D-399H-A 72147-SHJ-A21

An inexpensive replacement for your original remote key fob, the Keyless2Go car key replacement is self-programmable and comes with easy do-it-yourself instructions to help you program your new car key at home. Enjoy keyless entry on your Honda Odyssey. Each fob key has been pre-tested to ensure fitment and that signals are transmitting properly. Every remote key fob comes complete with batteries and free tech support to help get your new smart key working.

Compatible with:

2005-2010 Honda Odyssey

HONDA ODYSSEY REMOTE PROGRAMMING

Entering the programming mode cancels all learned keyless remotes, so none of the previously programmed remotes will work. You must reprogram all of the keyless remotes once you are in the programming mode. You must complete each step within 5 seconds of the previous step to keep the system from exiting the programming mode.

Note: a maximum of 3 remote transmitters can be programmed.

Make sure all the doors are CLOSED and UNLOCKED before starting this programming procedure.

1. Turn ignition switch to ON (II) – dash lights turn on 2. Press the LOCK or UNLOCK button on one of the remotes. (An unprogrammed remote can be used for this step.) 3. Turn ignition switch to ACCESSORY (I) or LOCK (O) – dash lights go off

4. Turn ignition switch to ON (II) 5. Press the LOCK or UNLOCK button on one of the remotes. 6. Turn ignition switch to ACCESSORY (I) or LOCK (O)

7. Turn ignition switch to ON (II) 8. Press the LOCK or UNLOCK button on one of the remotes. 9. Turn ignition switch to ACCESSORY (I) or LOCK (O)

10. Turn ignition switch to ON (II) 11. Press the LOCK or UNLOCK button the same remote. Make sure the power door locks cycle to confirm you are in programming mode.

12.Press the LOCK or UNLOCK button on each remote you want to program. Make sure door locks cycle after you push each remote button to confirm system has accepted the remote. 13.Turn the ignition switch to LOCK (O) to exit programming mode.

14. Test remote(s)