Features
Notes: The iDatalink Maestro HRN-RR-HO2 installation harness requires the purchase of the iDatalink Maestro RR or RR2 (sold separately).
Honda Harness: The iDatalink Maestro HRN-RR-HO2 installation harness greatly simplifies the installation of the Maestro RR or RR2 Car Radio Replacement Interface module (sold separately) in select Honda vehicles when replacing your factory radio with an iDatalink Serial Port compatible head unit from Kenwood, JVC, Alpine, Sny, or Pioneer.
Retained Features: The following factory features (if applicable) are retained when replacing your factory radio with a compatible iDatalink Serial Port head unit from Kenwood, JVC, Alpine, JVC, Sny, or Pioneer using the Maestro RR or RR2 Car Radio Replacement Interface module and HRN-RR-HO2 installation harness.
- Factory Amplifier
- Aux Input & Secondary Vehicle Display (if equipped)
- Bluetooth
- Steering Wheel Controls
- Multi-Angle Backup Camera with Parking Guidelines (multi-angle control and parking guidelines only supported by specific Kenwood and JVC radios)
- Lane Watch Camera (your compatible iDatalink Maestro receiver will need a second camera input for the Lane Watch Camera feature to be retained; includes specific Kenwood, JVC, and Sny radios)
Extra Features: The following Extra features are added when replacing your aftermarket head unit with a compatible iDatalink Serial Port head unit from Kenwood, JVC, Pioneer, Sny, or Alpine using the Maestro RR or RR2 Car Radio Replacement Interface module and HRN-RR-HO2 installation harness.
- Selectable Performance Gauges
- Vehicle Information such as Battery Voltage Display, Read/Reset Check Engine Codes, and Door Open Status/Warning
Connections: The iDatalink Maestro HRN-RR-HO2 installation harness contains three Molex connectors which plug into your factory radio harness. On the other end of the harness are four multi-pin connectors which plug into the Maestro RR or RR2 Car Radio Replacement Interface module. In addition, you will need to hardwire the power/ground, illumination, speaker, and navigation output leads of the HRN-RR-HO2 harness to your aftermarket head unit's wiring harness. In addition, stereo RCA connectors connect to your aftermarket head unit's front, rear, and sub pre-outs. There is also a composite video jack and a 3.5mm minijack to plug into your aftermarket head unit's rear-panel camera input and Aux input.