The iCreatin PoE Injector can save you money by using an existing Ethernet line to deliver data and power. The iCreatin PoE Injector can easily connect any IEEE 802.3af/at Compliant device to a non-PoE LAN switch port. This PoE Injector can be used to connect a wireless access point, IP phone, network camera, or any IEEE 802.3af/at powered device to a LAN switch. Reduce Wiring Costs With the iCreatin PoE Injector you can dramatically reduce wiring costs by powering devices through your existing Ethernet line rather than running new AC power lines. To use this PoE injector, all you need to do is connect the iCreatin PoE Injector to the LAN switch port, and then use your existing Ethernet Cable to deliver DC power and data to your device. Protect Your Equipment Now that you are running DC power to your networked equipment through the Cat5 cabling, you need to be sure that your devices are protected from power problems. The iCreatin PoE Injector is designed with short circuit protection Over Current and Over Voltage Protection, keeping your devices safe. It is also protect your products from overloads and high voltages Specifications 2 Gigabit Ethernet ports Input 100-240V voltage Output Rated 60Watt, Max 65W , Data rate: 10\100\1000Mbps, Power feed: Supports both Mode A and Mode B Deliver power up to about 328 feet(100 meters) What in Box? 1x 60 watt Gigabit PoE injector 1 x US power cord"

High Performance Gigabit PoE/PoE+ injector, IEEE 802.3af/802.3at compliant. Pin Assignment and Polarity: 1/2 (-), 3/6 (+),4/5(+), 7/8(-). Plug & play, no configuration is needed, simply connect a PoE network device, accommodates most installations scenarios. Converts a non-PoE Gigabit port to a PoE+ Gigabit port and Network a PoE device located up to 100 meters (328 ft.) away. Auto-sensing technology delivers up to 60W to a PoE+ device with backwards compatibility for 802.3at(30w) and 802.3af PoE (15.4W) devices. 1 Gigabit Ethernet port input and 1 PoE+ Gigabit Ethernet port output offer full duplex 2Gbps Ethernet speeds.