HiLetgo 3pcs SN65HVD230 CAN Bus Transceiver Communication Thermal Protection Slope Control Module for Arduino Controller Board

BE SAFE

WE ONLY SOURCE

FROM OFFICIAL SUPPLIERS

From United States

To International

In 5-10 Days

US$19.99 Shipping Fees for any Order

GRAND SELECTION

Think of it and most probably we have it among our grand selection of products!

AMAZING PRICES

Get ready for the amazing and best Supps prices ever!

FIXED RATE DELIVERY

Get your order anywhere on this planet within 5-10 days with a fixed rate of $19.99 (no matter the size of your order)

+1 (844)-467 8777

PHONE:

+1 (844)-467 8777

HiLetgo 3pcs SN65HVD230 CAN Bus Transceiver Communication Thermal Protection Slope Control Module for Arduino Controller Board

Regular Price: US$23.99

Special Price US$19.99

Availability: In stock

Supplier: HiLetgo

Category: Electronics Computers & Accessories Computer Components Single Board Computers

Qty:

Frequently bought together :

Price for all selected :

US$39.98

: SN65HVD230 can be used under high interference environment. The device has the ability to send and receive good at different rates, and its main features are as follows: Fully compatible with ISO11898 standard; High input impedance, allowing 120 nodes; Low current standby mode, the typical current of 370µA; Signal transfer rate up to 1Mb / s; Thermal protection, open circuit failure protection function; With anti-instantaneous interference protection bus; Slope control, reduce radio frequency interference (RFI); Differential receiver with a wide range of anti-common-mode interference, electromagnetic interference (EMI) capabilities. Operating modes and control logic: SN65HVD230 high speed, slope and wait three different modes of operation. Its working mode control can be achieved by the control pin Rs. Figure 2 is a SN65HVD230 CAN bus system in a typical application diagram. Can be seen from the figure, CAN controller is connected to the output pin Tx SN65HVD230 data input terminal D, this data can be transferred to the CAN node sends CAN network; CAN controller and receive pins of Rx and SN65HVD230 R is connected to the data output terminal, for receiving data. Select the port Rs SN65HVD230 way via jumpers and end of the ground slope resistor can be achieved through hardware mode select three modes of operation, in which the slope is 0 ~ 100kO resistor potentiometer Package Included: 3 * SN65HVD230 CAN bus transceiver communication module

Low current standby mode, the typical current of 370µA. High input impedance, allowing 120 nodes. Fully compatible with ISO11898 standard. The device has the ability to send and receive good at different rates. SN65HVD230 can be used under high interference environment.