HiLetgo 2pcs ESP8285 ESP-01M IR Infrared Transmitter Receiver Module Digital Infrared Transceiver Sensor WiFi Remote Control Switch

BE SAFE

WE ONLY SOURCE

FROM OFFICIAL SUPPLIERS

From United States

To International

In 5-10 Days

US$19.99 Shipping Fees for any Order

GRAND SELECTION

Think of it and most probably we have it among our grand selection of products!

AMAZING PRICES

Get ready for the amazing and best Supps prices ever!

FIXED RATE DELIVERY

Get your order anywhere on this planet within 5-10 days with a fixed rate of $19.99 (no matter the size of your order)

+1 (844)-467 8777

PHONE:

+1 (844)-467 8777

HiLetgo 2pcs ESP8285 ESP-01M IR Infrared Transmitter Receiver Module Digital Infrared Transceiver Sensor WiFi Remote Control Switch

Regular Price: US$35.99

Special Price US$29.99

Availability: In stock

Supplier: HiLetgo

Category: Electronics Computers & Accessories Networking Products Network Transceivers

Qty:

Description: This is a Infrared ESP8285 Wireless WIFI Transceiver Module.The ESP-01M module with ESP8285 as the core be used as the master control, The program is the same as ESP8266. The module board is equipped with an infrared receiving tube and an infrared transmitting tube which are respectively io14 and io4 controlled, and a burning port is set apart. The demonstration program can read and emit infrared key values and raw codes,user can record infrared remote controls in your home , which can be controlled remotely if connected to the Internet of things platform. Firmware Update: 1.Connect IO0 and GND pins. 2.Connect module to PC by USB to UART converter. 3.Open software 'FLASH DOWNLOAD TOOLS V3.6.4'. 4.Set parameters. 5.Click START to download firmware. 6.Remove connect between IO0 and GND pins then update complete. Connect with TTL downloader: GND -------- GND 5V -------- 5V RX --------- TX TX --------- RX When programming a program, IO0 and GND must be short-circuited, and the module needs to be powered on again; after programming, disconnect IO0 and GND and power on again to run the program normally. Note: When supplying power, you need pay attention on 5V and GND. There is no reverse connection protection for the circuit, otherwise the chip may be burned out if connected incorrectly. Package included: 2* ESP8285 ESP-01M Digital Infrared Transceiver Sensor Module

Work Voltage:DC 5V; Size:23.4*23.4*18mm. Support infrared control, wireless WIFI control and firmware update. ESP8285 ESP-01M IR Infrared Transmitter Receiver Module.