Geekstory BE-880Q GPS Module with Flash QMC5883L Compass GPS Antenna TTL Level 38400bps for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller

BE SAFE

WE ONLY SOURCE

FROM OFFICIAL SUPPLIERS

From United States

To International

In 5-10 Days

US$19.99 Shipping Fees for any Order

GRAND SELECTION

Think of it and most probably we have it among our grand selection of products!

AMAZING PRICES

Get ready for the amazing and best Supps prices ever!

FIXED RATE DELIVERY

Get your order anywhere on this planet within 5-10 days with a fixed rate of $19.99 (no matter the size of your order)

+1 (844)-467 8777

PHONE:

+1 (844)-467 8777

Geekstory BE-880Q GPS Module with Flash QMC5883L Compass GPS Antenna TTL Level 38400bps for Arduino Raspberry Pi Aircraft Pixhawk APM Flight Controller

Regular Price: US$53.99

Special Price US$44.99

Availability: In stock

Supplier: Geekstory

Category: Electronics GPS & Finders & Accessories GPS System Accessories Antennas

Qty:

Features Chip: M10050 Compass: QMC5883L. Frequency: GPS L1 C/A,QZSS L1 C/A/S,BDS B1I/B1C,Galileo E1B/C,SBAS L1 C/A:WAAS,EGNOS,MSAS,GAGAN Operation Mode: GPS+BDS+GALILEO+SBAS+QZSS Sensitivity: Track -166dBm, Re-arrest -160dBm, Cold Start -148dBm, Hot Start -160dBm Horizontal Accuracy: 1.5m CEP 2D RMS SBAS Auxiliary(for open sky) Speed Accuracy: 0.05m/s Dynamic Heading Angle Accuracy: 0.3 deg 1PPS Time Accuracy: RMS 30ns, 99% 60ns Start Time: Cold Start 27s, Hot Start 1s, Assisted Start 1s Baud Rate: 4800bps - 921600bps, default 38400bps Output Level: TTL level Output Protocol: NMEA, UBX NMEA Sentences: RMC, VTG, GGA, GSA, GSV, GLL Update Frequency: 0.25Hz - 18Hz, default 1Hz Second Pulse: Configurable from 0.25Hz to 10MHz, default period 1s, high level last for 100ms Graviational Acceleration: <4g Voltage: DC 3.6V - 5.5V, Typical 5.0V Current: Normal 50mA/5.0V Size: 28*28*8.4mm Connector: 1.25mm 6pin Package Included 1 x BE-880Q gps module 3 x cables See more

Baud Rate : 4800bps to 921600bps, Default 38400bps. You can set the baud rate you need in this range according to your needs. DIts data Level is TTL or RS-232, Default TTL level. To make it be RS232 output, you need to use one TTL to RS232 converter cable. When you use it for Raspberry Pi, there is no driver needed. Here is connection with RPi, red to 3.3v, black to GND, green to TXD white to RXD. The blue (TX) light flashes when power on, indicating there is data output. BE 880Q gps module has flash to save configuration. So you do not need to reset next time when you use it. This BE-880Q GPS Module using the latest 10th generation chip. BE-880 gps module is dual module compass, with and electronic compass IC QMC5883L.