EC Buying ESP32-S3-DevKitC-1 N8R2 Development Board Based on ESP32-S3-WROOM-1 Module 8MB Flash 2MB PSRAM

BE SAFE

WE ONLY SOURCE

FROM OFFICIAL SUPPLIERS

From United States

To International

In 5-10 Days

US$19.99 Shipping Fees for any Order

GRAND SELECTION

Think of it and most probably we have it among our grand selection of products!

AMAZING PRICES

Get ready for the amazing and best Supps prices ever!

FIXED RATE DELIVERY

Get your order anywhere on this planet within 5-10 days with a fixed rate of $19.99 (no matter the size of your order)

+1 (844)-467 8777

PHONE:

+1 (844)-467 8777

EC Buying ESP32-S3-DevKitC-1 N8R2 Development Board Based on ESP32-S3-WROOM-1 Module 8MB Flash 2MB PSRAM

Regular Price: US$53.99

Special Price US$44.99

Availability: In stock

Supplier: EC Buying

Category: Electronics Computers & Accessories Computer Components Single Board Computers

Qty:

Main components ESP32-S3-WROOM-1 (Universal WiFi+low-power Bluetooth MCU module with rich peripheral interfaces, powerful neural network computing, and signal processing capabilities, using PCB onboard antennas) 5V to 3.3V LDO (power converter input 5V, output 3.3V) Pin Headers (all available GPIO pins (except for the SPI bus of flash) have been led out to the development board pins) USB to UART Port (Micro USB interface, can be used as the power interface for the development board, can be used as a communication interface to communicate with the chip through an onboard USB to UART bridge) Boot Button (Download button. Press and hold the Boot key while pressing the Reset key to enter the "Firmware Download" mode and download the firmware through the serial port) Reset Button ESP32-S3 USB Port (USB OTG interface, supporting full-speed USB 1.1 standard. Can be used as a power interface for development boards, can burn firmware to chips, can communicate with chips through USB protocol, and can also be used for JTAG debugging) USB to UART Bridge (single chip USB to UART bridge, providing up to 3 Mbps transfer rate) RGB LED (Addressable RGB LED, driven by GPIO48) 3.3 V Power On LED (this indicator light comes on when the development board is connected to a USB power supply)

Most pins of the module on the board have been led out to the rows of pins on both sides. According to the actual needs, it is easy to connect a variety of peripheral devices through jumpers. At the same time, the development board can also be inserted into the Breadboard for use. UI: Boot Button; Reset Button; RGB LED; 3.3 V Power On LED. Interface: USB to UART Port; ESP32-S3 USB Port. ESP32-S3 DevKitC-1 is a development board based on the ESP32-S3 WROOM-1 and ESP32-S3 WR0OM-1U modules. Product model: ESP32-S3-WROOM-1-N8R2; Flash: 8 MB, 4-wire, 3.3V; PSRAM: 2 MB, 4-wire, 3.3V; Antenna type: PCB built-in antenna.