Drinking Water Test Kit for Lead (Twin Pack)

BE SAFE

WE ONLY SOURCE

FROM OFFICIAL SUPPLIERS

From United Kingdom

To International

In 5-10 Days

US$19.99 Shipping Fees for any Order

GRAND SELECTION

Think of it and most probably we have it among our grand selection of products!

AMAZING PRICES

Get ready for the amazing and best Supps prices ever!

FIXED RATE DELIVERY

Get your order anywhere on this planet within 5-10 days with a fixed rate of $19.99 (no matter the size of your order)

+1 (844)-467 8777

PHONE:

+1 (844)-467 8777

Drinking Water Test Kit for Lead (Twin Pack)

Regular Price: US$88.99

Special Price US$74.99

Availability: In stock

Category: Pet Supplies Fish & Aquatic Pets Aquariums & Accessories

Qty:

Frequently bought together :

Price for all selected :

US$184.97

Lead in drinking water is mostly caused by lead pipes especially in houses built prior to the 1930s. The lead concentration is normally higher when the water is softer, ie. has a lower pH. When lead enters the body it can cause damage to the central nervous system as well as cause developmental harm especially in children and infants, neurological and kidney damage. Once lead has entered the body it is released very slowly, which means ongoing exposure will cause a build up of lead in the body.

The amount of lead in water caused by lead piping is greater when the water has been sitting in the pipe for a while, ie. in the first water of the morning. It is therefore important to let the water run to flush the pipe before using it. Because lead levels in the water can vary throughout the day, it is recommended to test your drinking water more than once - ideally throughout one day whenever you use your water for consumption.

The UK maximum contaminant level for Lead in tap water set by DWI/DEFRA is 10µg/l (= 0.01mg/l = 0.01ppm).


Suitable for: fresh water samples, including water from taps, wells, springs, boreholes, ponds, as well as rain water	Sensitivity: presence/absence measured at a level of 5ppb (= 0.005 mg/l)	Contains: 2 tests for Lead in drinking water Total Test Time: approx. 10 minutes

How to Use:

The Watersafe Lead Test can detect dissolved lead at levels below the EPA Action level of 5 ppb (parts per billion).

Open Lead packet and take out all contents. The foil packet contains a test vial, a dropper pipette, one test strip, and a desiccant (to be discarded).
Using dropper, place water sample into test vial. To pick up the sample, tightly squeeze the bulb at the end of the dropper and place the open end into the water sample. Release the bulb to pick up the sample, then squeeze again to expel the sample into the vial. Use only one pipette-full of water.
Swirl vial gently for several seconds. Place on a flat surface.
Place test strip into the test vial, with arrows pointing DOWN
Wait 10 minutes. Do not disturb strips or vial during this time. Lines will appear on the strip.
Take the strip out of the vial and read result.


Negative: Bottom line (next to number 1) is darker than the top line (next to number 2).	Positive: Top line (next to number 2) is darker than the bottom line (next to number 1), or lines are equally dark.	If a test strip shows a positive result, your water sample may contain lead at a toxic level. Take appropriate action.

Sensitivity: presence absence measured at a level of 5ppb ( 0.005 mg l). Simple to use - Easy instructions. Contains 2 x Tests for Lead - takes 10 minutes to complete. This Lead Test can detect dissolved lead at levels below the EPA Action level of 5 parts per billion (ppb).