The four spindles on the trackball have a tiny circular magnet the end; each of these are paired with an SMD hall effect sensor, which are used to measure up, down, left and right movements of the trackball. An SMD momentary switch is placed under the trackball to give you a select switch. The BTN line will be pulled low when the switch is pressed. Also included on the Trackballer are 4 LEDs: red, blue, green and white. These can be powered to light the clear trackball up any color you can imagine. All features are broken out to a 0.1" pitch header. Regulated, 2.5-5.25VDC power must be provided to power the Hall sensors. The trackball is attached with strong CA glue. Board comes as shown, with all components populated. The hall-effect sensors and trackball combo are surprisingly sensitive. A slight roll of the trackball creates multiple high/low transitions on the four axis pins, easily picked up by any microcontroller essentially giving you the option of adding a mouse to your project. A 360¡ã rotation of the trackball, along a single axis, will result in about 9 high/low transitions. Working voltage:2.5~5.25V PCB Size: 22*28mm Package Included: 1 x Blackberry Trackball Breakout Board Module 2 x Replacement Trackball and Ring 1 x 10PIN male and female DuPont cable See more

【Item Condition】: The module is 100% made of original electronic components, and the product is a brand new product, you can buy it with confidence. 【Fact note】: A slight roll of the trackball creates multiple high/low transitions on the four axis pins, easily picked up by any microcontroller essentially giving you the option of adding a mouse to your project. 【Trackball】: The four spindles on the trackball have a tiny circular magnet the end; each of these are paired with an SMD hall effect sensor, which are used to measure up, down, left and right movements of the trackball. 【Parameters】: Working voltage: 2.5~5.25V; PCB Size: 22*28mm. 【Switch】: An SMD momentary switch is placed under the trackball to give you a select switch. The BTN line will be pulled low when the switch is pressed.