Description: Specification: The module (Micro SD Card Adapter) is a Micro SD card reader module, and the SPI interface via the file system driver, microcontroller system to complete the Micro SD card read and write files. Arduino users can directly use the Arduino IDE comes with an SD card to complete the library card initialization and read-write Features: 1 Support Micro SD Card, Micro SDHC card (high-speed card) 2 the level conversion circuit board that can interface level is 5V or 3.3V 3 power supply is 4.5V ~ 5.5V, 3.3V voltage regulator circuit board 4. Communication interface is a standard SPI interface 5. 4 M2 screw positioning holes for easy installation Control Interface: A total of six pins (GND, VCC, MISO, MOSI, SCK, CS), GND to ground, VCC is the power supply, MISO, MOSI, SCK is the SPI bus, CS is the chip select signal pin; 3.3V regulator circuit: LDO regulator output 3.3V as level converter chip, Micro SD card supply; Level conversion circuit: Micro SD card into the direction of signals into 3.3V, Micro SD card toward the direction of the control interface MISO signal is also converted to 3.3V, general AVR microcontroller system can read the signal; Micro SD card connector: yes since the bomb deck for easy card insertion and removal. Positioning holes: 4 M2 screws positioning hole diameter of 2.2mm, the module is easy to install positioning, to achieve inter-module combination; Package includes: 5 x Micro SD TF Card Shield Expansion Board for Arduino DIY 1 x 30Pin Dupont Cable Female to Female 1 x 30Pin Dupont Cable Female to Male

Positioning holes: 4 M2 screws positioning holes diameter of 2.2mm, the module is easy to install positioning, to achieve inter-module combination. Micro SD card connector: yes since the bomb deck for easy card insertion and removal. Level conversion circuit: Micro SD card into the direction of signals into 3.3V, Micro SD card toward the direction of the control interface MISO signal is also converted to 3.3V, general AVR microcontroller system can read the signal. 3.3V regulator circuit: LDO regulator output 3.3V as level converter chip, Micro SD card supply. The module is a Micro SD card reader module, and the SPI interface via the file system driver, microcontroller system to complete the Micro SD card read and write files. Arduino users can directly use the Arduino IDE comes with an SD card to complete the library card initialization and read-write.