Instructions for maintenance. PREMISE: all tools have their own intended use. Use for the purpose for which they were built to avoid damage, malfunction or injury to people. MAINTENANCE: always keep the tips of the tools protected and avoid accidental knocks or falls. CLEANING AND STERILIZATION: bear in mind the following fundamental indications: 1. carefully clean the instruments in order to eliminate all organic and inorganic residues using non-abrasive brushes and pipe cleaners or iron and/or ultrasound cleaning machines. If specific detergents are used, scrupulously follow the manufacturer's instructions, respecting the established methods and times; 2. Steam sterilization by autoclaving is recommended, following the procedures correctly. If sterilizing powders or liquids are used, carefully follow the dosing and soaking instructions indicated by the manufacturer, to avoid the risk of corrosion even of the stainless steel; 3. pay particular attention to the rinsing and drying phase: thoroughly cleanse the instruments with running water (or follow the instructions of the sterilizing agent manufacturer) and proceed with drying, taking care to remove all residues of water and/or or humidity. We recommend the use of compressed air spray AIRY cod. CO-427A; 4. lubricate the parts subject to friction (joints, recesses, joints and screws). We recommend the use of LUBSIL silicone lubricant cod. CO-417S. RECOMMENDATIONS: Incorrect cleaning, disinfection and/or sterilization procedures can cause the formation of corrosion and/or blackening of the instruments. INGREDIENTS Acciaio inox

Materials with deteriorated parts (breakage, etc.) or rust must be repaired or treated with specific products, or destined for a new session of the cycles to which they have already been subjected. The instruments must not be subjected to treatments at high temperatures: it is advisable to observe the instructions when carrying out the sterilization cycles using the suitable time temperature steam parameters. Drying is important for the success of the entire process, especially with regard to the conservation of tools: the materials must be dried thoroughly using clean, soft towels, or, preferably, with compressed air, which facilitates the removal of such residues from hollow parts, recesses and seams. Failure to dry may cause corrosion, oxidation of instruments and/or staining. After cleansing, the instruments must be rinsed under running water to leave no traces of the liquids used. The use of demineralised water is recommended. most water systems carry water containing mineral particles and the pipes accumulate residues over the years which will deposit on your instruments encrusting and staining them. RECOMMENDATIONS: Incorrect cleaning, disinfection and/or sterilization procedures can cause the formation of corrosion and/or blackening of the instruments. Traditional line of instruments in stainless steel, with a non-slip and non-reflective finish. Also sterilizable in an autoclave. In order to avoid damage, compromising its use, it is recommended:. Blue Farm, in the province of Pordenone, is the place where the company grows and develops, where the idea of beauty comes to life through an innovative concept of interaction with the final consumer. Company collaborators and visitors can develop and share ideas, and directly experience the various aspects dedicated to body care.