How to use Opening Wheel ? STEP 1

Starting on the left side of the display, near the power button, insert the Display Opening Tool into the gap between the glass and the back case.

How to use Opening Wheel ? STEP 2

The pin on the iMac Opening Tool will prevent the wheel from going too far in. If you will be using a different tool, insert it no more than 9.5mm into the display. You could ruin the antenna cables and cause serious damage.

How to use Opening Wheel ? STEP 3

Use the tool like a pizza cutter—roll it along through the gap, and it will cut the foam adhesive through the center.

Be sure to always push with the handle behind the cutting wheel. If you pull, the wheel might get pulled out of the handle.

Run the tool up along the left side of the display.

How to use Opening Wheel ? STEP 4

Finish pushing the opening tool to the bottom of the right side of the display.

At this point, you'll want to run the tool back around the entire display, to ensure you cut as much adhesive as possible.

Bfenown Guide 1

• Start with strip 13, which goes on the right vertical edge of the Display frame.
• Before you peel off any backing, line the adhesive strip up along the frame of the Display to get an idea of where it goes.

Bfenown Guide 2

Peel the short piece of backing off the back of the strip.

Bfenown Guide 3

Do not peel off the front adhesive backing yet.

Bfenown Guide 4

Insert the tip of a spudger into the hole at the end of the strip where you just removed one layer of backing. Insert the spudger from the side that still has a layer of white backing on it.

With the spudger still poking through the hole in the adhesive strip, push the spudger tip into the corresponding hole in the frame of the iMac.

Using the hole and spudger to anchor the position of the adhesive strip, line the strip up against the right edge, gently pull down against the spudger to ensure the strip is taut, and stick it onto the frame.