1x Finger Splint (1 Splint) A rigid splint to straighten and limit the DIP finger joint moving! Please be sure to double check sizing against your own fingers before buying. Measure by taking the Circumference of the DIP joint of the finger (Joint below finger nail) These splints straighten and limit movement in the DIP joint. Sizing can be viewed in the photos as well as an example of how to measure your DIP joint. Sizing (Length x Width): Please note width opens up for application. TO FIND YOUR SIZE MEASURE AROUND THE DIP JOINT (JOINT BELOW FINGER NAIL) SEE 3RD LISTING PHOTO FOR AN EXAMPLE OF HOW TO MEASURE THE JOINT. If your DIP joint circumference is at the top end between two sizes we suggest the larger size. All splints will come off if you pull them but should not fall off when moving the hand normally. Size 0: 5.0 cm x 1.6 cm SUITABLE FOR DIP JOINT: 4.4 cm - 5 cm LITTLE FINGER ONLY.* Size 1: 5.0 cm x 1.8 cm SUITABLE FOR DIP JOINT: 4.9 - 5.5 cm All Fingers except Thumb.* Size 2: 5.6 cm x 2.0 cm SUITABLE FOR DIP JOINT: 5.0 - 5.9 cm All Fingers except Thumb.* Size 3: 5.7 cm x 2.1 cm SUITABLE FOR DIP JOINT: 5.6 - 5.9 cm All Fingers and Small Thumbs ** Size 4: 5.8 cm x 2.1 cm SUITABLE FOR DIP JOINT: 6.0 - 6.3 cm Thumb and All Fingers except little* Size 5: 6.0 cm x 6.0 cm SUITABLE FOR DIP JOINT: 6.4 - 7.5 cm Thumb Only *** *All fingers mentioned are recommendations due to the finger tip section of the splints narrowing on smaller sizes. **Size 3 may fit small thumbs if the DIP joint is in range, the tip of this splint narrows so if it is too tight please leave a gap between the tip of the thumb and the tip of the splint before fastening the strap. ***Size 5 has been tested on an 8cm DIP joint, it did fit but it was tight and applied pressure to the thumb. How to use: 1. Undo the velcro strap to open up the body of the splint 2. Slide your finger into the splint so you can see your finger nail through the big hole at the top 3. Fasten the strap making sure it is tight enough to limit movement. TIP: If you find the top section is digging into the finger then slide it up slightly before tightening, leaving a small gap between the top of the splint and the finger tip.

Size 5: SUITABLE FOR DIP JOINT: 6.4 - 7.5 cm Thumb Only. This size has been tested on an 8cm DIP joint, it did fit but it was tight and applied pressure to the thumb. Size 4: SUITABLE FOR DIP JOINT: 6.1 - 6.3 cm Thumb and All Fingers except Little Finger. Size 3: 5.7 cm x 2.1 cm SUITABLE FOR DIP JOINT: 5.6 - 6.0 cm All Fingers and Small Thumbs (This size may fit small thumbs if the DIP joint is in range, the tip of this splint narrows so if it is too tight please leave a gap between the tip of the thumb and the tip of the splint before fastening the strap.). Size 2: SUITABLE FOR DIP JOINT: 5.0 - 5.9 cm All Fingers except Thumb. Size 1: SUITABLE FOR DIP JOINT: 4.9 - 5.5 cm All Fingers except Thumb. Size 0: SUITABLE FOR DIP JOINT: 4.4 cm - 5 cm LITTLE FINGER ONLY. All splints will come off if you pull them but should not fall off when moving the hand normally. If there is any swelling in the area during transit the DIP joint measurement can change, please take this into account when selecting a size. BRAND NEW SIZING GUIDE! We heard your feedback and did market research to improve our sizing guide. You MUST measure round the TOP JOINT (DIP) of the finger for correct size. SEE PHOTOS FOR EXAMPLE. A rigid splint to straighten and limit the DIP finger joint moving. If you find the top section is digging into the finger then slide it up slightly before tightening, leaving a small gap between the top of the splint and the finger tip.