AudioControl The Epicenter Micro - Bass Restoration Processor & Line Output Converter

The Epicenter Micro

Bass Restoration Processor & Line Output Converter

The Epicenter Micro combines AudioControl’s legendary digital bass restoration with world-renowned OEM integration capabilities. Featuring a speaker-level input stage with selectable impedance loads, as well as traditional line-level inputs, The Epicenter Micro brings out the best bass in any system. Trigger modes include traditional +12v in, GTO Signal Sense, and Audio Sense. The PFM Subsonic Filter can be bypassed for the truly dedicated, and the 10V+ output voltage setting beckons only the bravest among us. Use the included ACR-4 controller to separately adjust bass restoration and output level.

You now possess the most advanced version of the legendary bass restoration and enhancement processor. The Epicenter, with over 1 million sold, is the veritable master of bass enhancement processing. Silky smooth bass lines will leap out of your speakers and that kick drum, whether it be the equally legendary 808 or the deep punch that can only come from a 28” kick, The Epicenter Micro will make every low frequency better.

The Epicenter Micro keeps everything you have come to know and love about AudioControl’s bass processing and added the OEM integration capabilities that AudioControl leads the world in. Speaker level input stage and the traditional line level inputs make The Epicenter Micro the go-to product for any application. Regardless of your age or music preference, the addition of an enhanced bass response to your mobile audio sound system makes for a truly amazing experience.

Being that we all vary in our bass response tastes, we’ve added even greater control over the bass response with the new ACR-4. The Epicenter effect as well as overall volume control are now part of the dual control ACR-4 controller knob. You can toss out that sub amp volume controller and install just the ACR-4 knob and have both styles of control at your fingertips!

Supreme ease of control, seamless of OEM integration and installation with world renown bass restoration, it’s pretty easy to just get going on the install straight away. Before you start taking apart the car to install this spectacular processor, please take a moment, grab a Georgetown Brewing Co., Johnny Utah Pale Ale and read though the details of the manual. The feature list is long so to take full advantage of everything we’ve packed into this baby, give this manual a decent read.

The AudioControl Epicenter Micro was designed to produce bass like you have never heard before. With that said it is important to take the following precautions during its use.

1. If you have an equalizer in your system, turn down the bass frequencies to zero boost.

2. You will want to reduce any other bass tone control, loudness control, or other secondary bass controls prior to turning on The Epicenter Micro. Once your system is up and running, you may want to use those secondary controls to dial the bass in a bit more but we doubt it!

3. Good bass response requires an appropriate choice of speakers and amplification. Since the bass frequencies always require more power and cone area than higher frequencies... BE PREPARED. Small speakers and lack of power will be detrimental to your system.

The Epicenter Micro needs to be installed in the signal path between a source and an external amplifier(s). Although it can be installed after an equalizer, it was designed to be installed before a crossover and other signal processors for optimal performance.

Once this is done, you just need to hook up power, ground, trigger, run the wire to the dash controller and tada!!! Instant bass. If you need to know more, then read on. Even if you don’t think you need to know more, you should still read on, because you can never know too much.