Aideepen 5pcs Dual H-Bridge DC Stepper 1.5A 2 Way DC Motor Driver Module Replace Stepper L298N for Smart Car Power MX1508

BE SAFE

WE ONLY SOURCE

FROM OFFICIAL SUPPLIERS

From United States

To International

In 5-10 Days

US$19.99 Shipping Fees for any Order

GRAND SELECTION

Think of it and most probably we have it among our grand selection of products!

AMAZING PRICES

Get ready for the amazing and best Supps prices ever!

FIXED RATE DELIVERY

Get your order anywhere on this planet within 5-10 days with a fixed rate of $19.99 (no matter the size of your order)

+1 (844)-467 8777

PHONE:

+1 (844)-467 8777

Aideepen 5pcs Dual H-Bridge DC Stepper 1.5A 2 Way DC Motor Driver Module Replace Stepper L298N for Smart Car Power MX1508

Regular Price: US$29.99

Special Price US$24.99

Availability: In stock

Supplier: Aideepen

Category: Electronics Computers & Accessories Computer Components Single Board Computers

Qty:

How did we get our start?

In 2009, an electronic lover began to produce/sell and share various products with two engineers in Shenzhen. Aideepen was established.

What keeps us going?

We have been committed to becoming an expert in this field, constantly developing until build own factory and R&D team,and expanding the team to more than 200 employees.

How do we do, if there's some issue with product?

Each product you purchase from Aideepen have 24 months service. You can get a new replacement if there's any quality issue with your items.
ESP32
Aideepen Transistor Meter
Aideepen Development Board

Aideepen 5pcs 1.5A 2 Way DC Motor Driver Module Speed Dual H-Bridge Replace Stepper L298N

Product parameters:

The module supply voltage 2V-10V.
Signal input voltage 1.8-7V.
Single Operating current 1.5A, peak current up to 2.5A, low standby current (less than 10uA).
Built-in common conduction circuit, when the input pin is left floating, the motor does not malfunction.
Built-in thermal protection circuit with hysteresis effects (TSD), without worrying about motor stall.
Product size: 24.7 * 21 * 5mm (length, width, height), ultra-small size.
The mounting hole diameter: 2 mm.

Precautions:

Power positive and negative reversed will certainly cause damage to the circuit.
Output is shorted to ground or output short circuit, and the motor stall, the chip will heat protection, but in the near or exceeding 10V voltage and peak current is greater than 2.5A situation can also cause chip burned.

Description:

Motor drive module is ideal for use in battery-powered smart car, toy cars, robots.

Supply voltage 2V ~ 10V, can drive two DC motors or a 4-wire 2-phase stepper motors ,can achieve forward rotation or reverse rotation, it is possible to adjust the rotation speed.

Each can provide continuous current of 1.5A, peak current up to 2.5A, thermal protection and can be automatically restored.

Product Highlights:
E of imported original chip, built-in low on-resistance MOS switch, minimal heat, no heat sink, small size, low power consumption, is ideal for battery powered.
(L298N internal transistor switch, low efficiency, need to add heat sink, bulky, L298N very easy to burn).
Dual 1.5A * 2, the peak current to be 2.5A, built-in thermal protection circuit, do not be afraid motor stall burned, automatic recovery after the temperature dropped.
Small size, light weight, low standby current, is the ideal choice for your car model.

Aideepen 5PCS L298N Dual H Bridge DC Stepper Motor Drive Controller Board Module

Main Chip: ST L298N, double H bridge drive
Low heat,outstanding anti-interference performance
High working power to 46v, large current can reach 3A max and continue current is 2A, power to 25w
Can drive one 2-phase stepper motor, one 4-phase stepper motor or two DC motors
Built-in 78M05, get power from drive power


	Aideepen 5pcs Dual H-Bridge DC Stepper	Aideepen 5PCS L298N Dual H Bridge DC Stepper	Aideepen 6-Pack MG996R Servo
Model	DC Stepper	DC Stepper	Servo

Small size, light weight, low standby current, is the ideal choice for your car model. Minimal heat, no heat sink, small size, low power consumption, is ideal for battery powered. Dual 1.5A * 2, the peak current to be 2.5A, built-in thermal protection circuit, do not be afraid motor stall burned, automatic recovery after the temperature dropped. Dual H-bridge motor driver, can drive two DC motors or a 4-wire two-phase stepper motor. Use of imported original chip, built-in low on-resistance MOS switch.