ACEIRMC 3pcs Type-C USB CH340 5V 16MHz for Nano 3.0 ATmega328P Controller Board Compatible for Arduino Nano CH340 USB Driver Nano V3.0 ATmega328 (Type-C)

BE SAFE

WE ONLY SOURCE

FROM OFFICIAL SUPPLIERS

From United States

To International

In 5-10 Days

US$19.99 Shipping Fees for any Order

GRAND SELECTION

Think of it and most probably we have it among our grand selection of products!

AMAZING PRICES

Get ready for the amazing and best Supps prices ever!

FIXED RATE DELIVERY

Get your order anywhere on this planet within 5-10 days with a fixed rate of $19.99 (no matter the size of your order)

+1 (844)-467 8777

PHONE:

+1 (844)-467 8777

ACEIRMC 3pcs Type-C USB CH340 5V 16MHz for Nano 3.0 ATmega328P Controller Board Compatible for Arduino Nano CH340 USB Driver Nano V3.0 ATmega328 (Type-C)

Regular Price: US$41.99

Special Price US$34.99

Availability: In stock

Supplier: ACEIRMC

Category: Electronics Computers & Accessories Computer Components Single Board Computers

Qty:

Input and Output Each of the 14 digital pins on the Nano can be used as an input or output, using pinMode(), digitalWrite(), and digitalRead() functions. Some pins have specialized functions: Serial: 0 (RX) and 1 (TX). Used to receive (RX) and transmit (TX) TTL serial data. These pins are connected to the corresponding pins of the CH340G USB chip. The Nano is a small, complete, and breadboard-friendly board based on the ATmega328 (compatible for Arduino Nano 3.x). It has more or less the same functionality of the official compatible for Arduino/Genuino UNO, but in a different package. It lacks only a DC power jack, and works with a Mini-B USB cable instead of a standard one. You could download the driver of Nano V3.0 . ATTENTION: We dont have USB cables in this kit and you will need to buy a mini USB cable to use this NANO board. PCB Size: 18 x 45 mm Weight: 7 g Package Include : 3 X Nano Board See more

Package Include : 3 X Nano Board. It is a smallest, complete, and breadboard friendly board. It has everything that Diecimila/Duemilanove has (electrically) with more analog input pins and onboard +5V AREF jumper. The Nano is using the chips ATmega328P and CH340, not FT232 as official compatible for Arduino, so pls. use the driver from above link. Nano's got the breadboard-ability of the compatible for Boarduino and the Mini+USB with smaller footprint than either, so users have more breadboard space. It's got a pin layout that works well with the Mini or the Basic Stamp (TX, RX, ATN, GND on one top, power and ground on the other). download the driver of Elegoo Nano V3.0 at: http://bit.ly/2jKlJMO.