ACEIRMC 10pcs 1.5A 2 Way DC Motor Driver Module Speed Dual H-Bridge Replace Stepper L298N (Mini Controller Board)

BE SAFE

WE ONLY SOURCE

FROM OFFICIAL SUPPLIERS

From United States

To International

In 5-10 Days

US$19.99 Shipping Fees for any Order

GRAND SELECTION

Think of it and most probably we have it among our grand selection of products!

AMAZING PRICES

Get ready for the amazing and best Supps prices ever!

FIXED RATE DELIVERY

Get your order anywhere on this planet within 5-10 days with a fixed rate of $19.99 (no matter the size of your order)

+1 (844)-467 8777

PHONE:

+1 (844)-467 8777

ACEIRMC 10pcs 1.5A 2 Way DC Motor Driver Module Speed Dual H-Bridge Replace Stepper L298N (Mini Controller Board)

Regular Price: US$23.99

Special Price US$19.99

Availability: In stock

Supplier: ACEIRMC

Category: Electronics Computers & Accessories Computer Components Single Board Computers

Qty:

Description: Motor drive module is ideal for use in battery-powered smart car, toy cars, robots. Supply voltage 2V ~ 10V, can drive two DC motors or a 4-wire 2-phase stepper motors ,can achieve forward rotation or reverse rotation, it is possible to adjust the rotation speed. Each can provide continuous current of 1.5A, peak current up to 2.5A, thermal protection and can be automatically restored. Product parameters: The module supply voltage 2V-10V. Signal input voltage 1.8-7V. Single Operating current 1.5A, peak current up to 2.5A, low standby current (less than 0.1uA). Built-in common conduction circuit, when the input pin is left floating, the motor does not malfunction. Built-in thermal protection circuit with hysteresis effects (TSD), without worrying about motor stall. Product size: 24.7 * 21 * 5mm (length, width, height), ultra-small size. The mounting hole diameter: 2 mm. Precautions: 1. Power positive and negative reversed will certainly cause damage to the circuit. 2. Output is shorted to ground or output short circuit, and the motor stall, the chip will heat protection, but in the near or exceeding 10V voltage and peak current is greater than 2.5A situation can also cause chip burned. Package Included: 10* Motor drive module

1.5A 2 Way DC Motor Driver Module Speed Dual H-Bridge Replace Stepper L298N. Minimal heat, no heat sink, small size, low power consumption, is ideal for battery powered. Dual 1.5A * 2, the peak current to be 2.5A, built-in thermal protection circuit, do not be afraid motor stall burned, automatic recovery after the temperature dropped. Dual H-bridge motor driver, can drive two DC motors or a 4-wire two-phase stepper motor. Use of imported original chip, built-in low on-resistance MOS switch.