High-shielding design

10G SFP+ DAC Twinax Cable for Cisco, Ubiquiti, D-Link, Supermicro, Netgear, Mikrotik, other Open Switches.

• Install a 10G DAC Cable:
• A. Install SFP+ Modules

1. Remove the protective ESD cap from the connector.
2. Slide the SFP+ cable end into the slot until it locks into position(There is an audible click when the connector is properly seated.)

• B. Remove SFP+ Modules

1. Pull on the SFP+ latch pull lanyard.
2. Grasp the SFP+ connector on both sides and remove it from the system.
3. If possible, replace the ESD protective cap or put the SFP+ into an ESD protected bag.

• Safety Information Notice:

1. The cables can only be installed or replaced by qualified personnel.
2. Please wear antistatic gloves.
3. Caution against moisture.
4. Do not disassemble or modify the cables.

• Warning: Don't approach or look the optical fiber exit with naked eyes directly. Excessive bending is strictly prohibited.

Sturdy SFP+ Connectors, 10G DAC Cable, Passive Twinax Direct Attach Copper 10GBASE-CU Cable for Cisco, Ubiquiti, D-Link, Supermicro, Netgear, Mikrotik

6COM is a manufacturer of transceiver. We offer many compatible options.