?Anti-slip and Tip Design?:A bright yellow line is added to the front of the floor wire cover,which can remind people to pay attention to it,so as not to step on it improperly,and it has a non-slip line design,which can prevent people from stepping on it and slipping. ?Installation Method?:Take out the floor cable cover and spread it out.Due to the properties of PVC,it has to be placed for a period of time to make it flat.Use a knife to cut along the groove on the back,and then put the wires need to be protected.You can cut the length whatever you like. ?Indoor and Outdoor?:Based on the design of this wire protector,it can be used indoors such as bedrooms,living rooms and offices,and it can be used outdoors either,such as courtyards and lawns,it's thick enough that you can drive over this,so it also called outdoor cable cover. ?3 Big Channel Design?:This floor wire cover is designed with 3 channel.The internal dimensions of the large hole in the middle is 0.94*0.4 inches,which can accommodate more than three ordinary wires at the same time.The inner size of the small holes on both sides is 0.75*0.35 inches,which can support two smaller electric wire. ?Upgraded Thick Soft PVC?:An upgraded version of the cable cover floor,thicker and softer.In order to better protect the wires,thicken the PVC appropriately. In order to facilitate installation,the wire cover is designed to be softer, without any peculiar smell,and the quality is guaranteed.