4Pcs ESP8266 Serial Wifi Module ESP-01 Updated Wireless Transceiver Board 3.3V for Arduino

BE SAFE

WE ONLY SOURCE

FROM OFFICIAL SUPPLIERS

From United States

To International

In 5-10 Days

US$19.99 Shipping Fees for any Order

GRAND SELECTION

Think of it and most probably we have it among our grand selection of products!

AMAZING PRICES

Get ready for the amazing and best Supps prices ever!

FIXED RATE DELIVERY

Get your order anywhere on this planet within 5-10 days with a fixed rate of $19.99 (no matter the size of your order)

+1 (844)-467 8777

PHONE:

+1 (844)-467 8777

4Pcs ESP8266 Serial Wifi Module ESP-01 Updated Wireless Transceiver Board 3.3V for Arduino

Regular Price: US$29.99

Special Price US$24.99

Availability: In stock

Supplier: Deegoo-FPV

Category: Electronics Computers & Accessories Computer Components Single Board Computers

Qty:

Frequently bought together :

Price for all selected :

US$44.98

ESP8266 is a highly integrated chip designed for the needs of a new connected world. It offers a complete and self-contained Wi-Fi networking solution, allowing it to either host the application or to offload all Wi-Fi networking functions from another application processor. Specifications: Serial/UART baud rate: 115200 bps Input power: 3.3V I/O voltage tolerance: 3.6V Max Flash Memory Size: 1MB (8Mbit) WiFi security modes: WPA, WPA2 Package Including 4 * ESP8266 Wifi Transceiver Module Version II---How to use Version II(All IO serial port version) Note:The power supply should be 3.3v!! about this version II,if you want to enter into AT command by FLASH boot,just need connect CH-PD pin with VCC pin or pull up resistor to keep high-level.(Sometimes without pulling up the resistor,there's no data on the serial port) The other three pins don't need to connect anything,if you connect them with VCC pin and failed restart,you shouldn't connect them.When GPIO0 is high-level,it means FLASH booting. When GPIO0 is low-level,it means upgrading the system.At this moment,you can upgrade the internal firmware by serial port. And RST(GPIO16)can be used to reset the external hardware. P.S.Different test systems may use different connecting ways,so you need choose the best connecting ways by yourself. Hereby we recommend one connecting way to connect esp01 module with serial port TTL tools.:After welding a 4.7k resistance between CH-PD pin and VCC pin. it needs connect UTXD,GND,VCC and URXD pin with USB-TTL(TXD and RXD need keep cross-linking)to test.

Complete and self-contained Wi-Fi networking solution. Updated version ESP-01,with stronger signal. ESP8266 is a WiFi enabled Microcontroller – Arduino ready. Model: Esp-01.Compatible with Arduino. Support 3 modes: AP, STA, AP + STA. Note: The item only supports 3.3V, please don't use 5V!.