3M VHB Heavy duty double sided foam tape

Emiterever two sided foam tape is perfect for a variety of mounting projects, This is a higher adhesive tape for more serious tasks. Thicker, super-stick tape in a convenient size. Get the right tape the first time to finish all your fix-its at home or at the office.

Removal Tips:

1.Use a heat gun or steamer to reduce adhesion.

2.Lift the edges with a sharp, flat tool.

3.Peel the edges slowly in one direction at an acute angle.

Application Guide:

1.Surface Cleaning: Quick pre-clean of tough spots if necessary. Wet cloth to remove most contaminants. Final wipe with dry cloth.

2.Priming the Surface: Primer on a disposable towel, followed by a dry towel. Dauber bottle followed by a dry towel. Foam brush.

3.Abrading Your Substrate: Light abrasion by hand. Clean the substrate after abrading to make sure all sanding debris is removed from the bond area.

4.Tape Application by Hand: Start the tape at the edge of the surface and lay it down, applying constant pressure as you go. Apply a roll down force of at least 15 lbs with a dense J-roller over the entire area to ensure good contact between the tape and the first substrate surface. Remove the protective liner to apply the other substrate.

5.Applying Final Pressure: Applying pressure to the applied tape facilitates optimal wet-out onto the substrate.

Application Guidelines :

25% strength of bond in 30 minutes, 50% strength of bond in 60 minutes, 75% strength of bond in 12 hours, and 100% strength of bond after 24 hours.

Double sided tape is black. Length 36FT, width 0.04 inches, Package Quantity: 1 roll