Features: PI Flash: default 32Mbit Ultra-small 802.11b/g/n Wi-Fi BT/BLE SoC module Bluetooth: Bluetooth 4.2 BR/EDR and BLE standards Low-power dual-core 32-bit CPU for application processors Main frequency up to 240MHz, computing power up to 600 DMIPS Built-in 520 KB SRAM, external 4M PSRAM Supports interfaces such as UART/SPI/I2C/PWM/ADC/DAC Support OV2640 and OV7670 cameras, built-in flash Image Output Format: JPEG( OV2640 support only ), BMP,GRAYSCALE Support image WiFi upload Support TF card Support multiple sleep modes Embedded Lwip and FreeRTOS Support STA/AP/STA+AP working mode Support Smart Config/AirKiss one-click distribution network Support secondary development Support for serial local upgrade and remote firmware upgrade (FOTA) Note: 1.Please make sure that the input power of module should be at least 5V 2A, otherwise the image will unstable. 2.Please pull GPIO32 low when the camera is working, because ESP32 GPIO32 pin controls camera power. 3. Do not connect high and low level when IO0 is connected to the camera XCLK, please leave IO0 floating. 4.It has default firmware before leaving factory, do not provide any additional download.Please handle it carefully if you need to re-burn other firmware. Package Included: 2x ESP32-CAM Module 1x Camera Module OV2640 2MPApplications: It can be widely used in kinds of IoT applications, prototypes constructions and DIY projects. It is suitable for home smart devices,wireless monitoring, industrial wireless control,QR wireless identification, wireless positioning system signals etc. Notes:Please make sure that the input power of module should be at least 5V 2A, otherwise the image will unstable.Please pull GPIO32 low when the camera is working, because ESP32 GPIO32 pin controls camera power. Support TF card and image WiFi upload. It compliant with 802.11b/g/n/e/i and Bluetooth 4.2 standards, which can be used as a master mode to build an independent network controller, or as a slave to other host MCUs to add networking capabilities to existing devices. The ESP32 board integrates WiFi, bluetooth and BLE Beacon, with Low-power dual-core 32-bit LX6 CPUs for application processors, 7-stage pipeline architecture, on-chip sensor, Hall sensor, temperature sensor etc. Main frequency adjustment ranges: 80MHz -240MHz, computing power up to 600 DMIPS. The ESP32-CAM is a WiFi+Bluetooth dual-mode development board based on ESP32 chip with onboard camera OV2640 2MP. It can work independently as a minimum system. You can program the ESP32-CAM through the ESP-IDF by installing the ESP32 Core as well. Besides, the board reserved the MPU6050,BME280 and an analog MIC.
