2 Port USB3.0 Display port KVM Hotkey Switch Dual Monitor 2 computers 4k 240hz `
KVM Switch Dual Monitor displayport with hotkey switching
Attention,please:
1. If need to support docking station, TYPE-C to DP, USB C to DP , thunderbolt, MAC. You must purchase our Type c to dp 1.4 kvm switch cable(ASIN: B0CM5X6F1W). Only this ASIN cable can support that, which requires additional purchase.
2.Adapters will be needed if your computer does not have dual DP outputs, powered HDMI to DP or USB C to DP adapters are preferred; This DisplayPort KVM switch does not support EDID emulation ,so the desktop locations may change upon switching and boot-up.
There are four ways to Switch PC1 TO PC2
1. Button mode: push the switch button on the kvm switch indicated ,you can switch to PC1 or PC2 by pushing the switch button
2. Wired remote button mode: you can switch PC1 OR PC2 by Wired remote button
3. Mouse mode: Double Click the middle roller of mouse +LB(Left Button) ,you can switch to PC1, Double Click the middle roller of mouse +RB(Right Button),you can switch to PC2.
4. Keyboard Hotkey Mode: You need to put the Hotkey button,them the Hotkey indcate on,right Control two times and number 1 and Enter(Ctrl+ctrl+1+Enter),you will switch to PC1,and (Ctrl+ctrl+2+Enter) you will switch to PC2
There are some special funtion,
Ctrl+Ctrl+B+Enter is used to open or close Buzzer.
Ctrl+Ctrl+R+Enter is used for the mouse and keyboard defalt,just reshart it.
Ctrl+Ctrl+Tab+Enter is used for open or close hotkey.
Ctrl+Ctrl+Esc+Esc+Esc+Enter is used for Restore factory settings