Overview This is an E-Ink display HAT for Raspberry Pi series boards, Jetson Nano. 2.13inch 250x122 resolution black and white Two Display colors, with embedded controller, communicating via SPI interface, supports partial refresh. Due to the advantages like ultra low power consumption, wide viewing angle, clear display without electricity, it is an ideal choice for applications such as shelf label, industrial instrument, and so on. Features No backlight, keeps displaying last content for a long time even when power down Ultra low power consumption, basically power is only required for refreshing Standard Raspberry Pi 40PIN GPIO extension header, compatible with Raspberry Pi series boards, Jetson Nano SPI interface, for connecting with other controller boards, likeArduino/Nucleo, etc. Onboard voltage translator, compatible with 3.3V/5V MCUs Comes with development resources and manual (examples for Raspberry Pi/Jetson Nano/Arduino/STM32) Specifications Operating voltage: 3.3V/5V Interface: SPI Resolution: 250 x 122 Display color: black, white Grey level: 2 Partial refresh time: 0.3s Full refresh time: 2s Refresh power: 26.4mW(typ.) Standby power: <0.017mW Viewing angle: >170° Dot pitch: 0.194 x 0.194 Outline dimension: 65mm x 30.2mm Display size: 23.71mm x 48.55mm Interface SYMBOL--DESCRIPTION VCC-- 3.3V/5V GND--Ground NC--NC DIN--SPI MOSI pin CLK--SPI SCK pin CS--SPI chip selection, low active DC--Data/Command selection (high for data, low for command) RST--External reset, low active BUSY--Busy status output, high active How-to-use Document/User Manual/FAQ: //bit.ly/3hZh77i PACKAGE CONTENT 2.13inch e-Paper HAT x1 RPi screws pack (2pcs) x1 PH2.0 20cm x1

Comes with online development resources and manual (driver board circuit diagram, examples for Raspberry Pi/Jetson Nano/Arduino/STM32). PLEASE READ THE ONLINE INFORMATION CAREFULLY BEFORE USING IT. Version Notice: The driver board is Rev2.1 (Version 2.1), which is independent of the screen version. Currently, there is only Rev2.1 (Version 2.1) for the driver board and QC label V4 is for the screen version, QC label V4 is currently being shipped. SPI interface, for connecting with controller boards likeArduino/STM32, etc. Onboard voltage translator, compatible with 3.3V / 5V MCUs. No backlight, keeps displaying last content for a long time even when power down. Ultra low power consumption, basically power is only required for refreshing. This is 2.13inch E-Ink display HAT with Raspberry Pi 40PIN GPIO extension header, compatible with Raspberry Pi series boards, Jetson Nano. 250x122 resolution, Black and White Two Display colors, with embedded controller, communicating via SPI interface, supports partial refresh.